How Efficiently Do You Use Your Taps?

Tuesday May 11, 2010

Whenever you install new taps in your bathroom or kitchen, you want to make the most of them and make sure they stay looking good all the time. But how good are you at saving water and making sure you don’t use them as often as you might?

The most important thing to remember with your taps is that they look good. You shouldn’t have any need to use them any more often than you did your old taps. And in fact, you should think about ways to reduce your use of them to cut down on the amount of water you use.

This is particularly beneficial if you happen to be on a water meter. A water meter can be more expensive than being on a set tariff if you use a lot of water. But if you are conscious of how you use it you can enjoy your new basin taps without having a larger bill on your hands either.

For starters always make sure they are fitted properly so they do not leak. Watch out for any signs of leaking when you first use them as well, to ensure they have indeed been fitted in the proper manner. Even over time you may eventually experience some degree of leaking; if this happens you will usually find you need to replace the washers. Different taps have different types of washers though – for instance some of them may be ceramic. Always make sure you get the right replacements for the basin taps you have.

In addition to this you should always be sure you turn the taps off fully when you have finished using them. If you don’t do this you may end up with a small but constant drip and that can waste water if it is left like that overnight or for any longer period of time. Furthermore you will find that if it happens almost continually it can stain your sink, and that can lead to problems getting it fully clean again.

As you can see, putting in new basin taps is just the beginning. You need to look after them and use them responsibly to make sure you don’t waste any water or end up using more of it than you really need to. Take a look at how you use your basin taps. Do they stand up to the job, or should you replace them for better ones?

 

Comment